SENIOR ENGINEER – QAD SQA

Education & Experience required:                                          

Qualification: BE or Diploma

Experience: Minimum 08 to 10 years of experience

Knowledge & Skills:       

• Inspection of raw material as per inspection plan /Drawing.
• GRN Closure in ERP/SAP.
• Maintenance of receiving inspection reports and documents
• Correspondence with supplier in case of RM defect & get SCAR
• Inspection plan preparations
• Preparation of AOI (Agreement of inspection) and sign off with supplier
• Coordination with other department like Engineering, Production, Purchase & Quality.
• DMR preparation process

Responsibilities: 

• GRN on time receiving inspection lot posting within 7 days
• Inspection of parts as per inspection plan and accuracy of reports.
• Documentation – Filing of hard & soft copy
• DMS, Portal & Computer – Uploading of COC, RIR, CQR immediately after inspection.
• Zero stoppage in FG dispatch due to COC, RIR, CQR issues
• On-time handing over of approved material within same day of UD posting
• GRN with proper stamp / traceability
• Rejected tag for NC parts:

1. 1. GRN Qty
   2. Entry/Acknowledgement in Stores’ logbook
   3. Proper usage of Vendor rejection location and adherence of DMR process
   4. Re-offer lots shall be cleared with Original GRN copy (Applicable to RI stage rejected parts, not applicable to shelf-life revalidation lots)
   5. Zero mistakes allowed & zero return of GRNs from Finance & Zero Supplier payment delay

• Preparation of SCAR and sending to supplier within same day of Inspection.
• Meeting or Con call with supplier to get the rejection acknowledgement for disposal and Corrective actions for NC parts & SCAR closure
• No Quality issues in production and No customer complaints and No Production halt hour
• Closure of Internal NCR for Production/Dispatch issues (Part Q issue & Document issue)
• Supplier visits – Q problem solving, Process audit, no rejection allowed at Hical if source inspection is done.
• IMTE – Management
• Gauge planning and ensure availability of gauges for mass production, Adhering budget planning & Procurement of planned measuring instruments, gauges etc.
• No usage of calibration overdue Instruments and Gauges
• Maintenance of Instruments and Gauges & Tracker updation
• Inspection plans created/corrected in SAP as per Drawing/TDS/Specification.
• Disposal of VRET rejection location